KAVU3275-E

The probable causes are:

• Memory could not be allocated at the transmission-destination manager host because the job's result files (standard output file and standard error output file) are too large.

  If this message is followed by messages KAVU2220-E and KAVU3512-E, a memory shortage on the destination manager host is likely. See the explanation of the messages output at the manager host.

• The temporary file used for job execution control did not exist. (reason-code = 0xe002110d)

• You did not have access permission for the temporary file used for job execution control. (reason-code = 0xe002110e)

• The amount of free space on the disk was insufficient when the temporary file used for job execution control was being created. (reason-code = 0xe002110f)

• The temporary file used for job execution control was locked and opened. (reason-code = 0xe0021110)

• An attempt to acquire the logical host name or IP address has failed. (reason-code = 0xe0021120)

Note

For details on the temporary files used for job execution control, see 7.8.1 Notes on the standard output file and standard error output file in the Job Management Partner 1/Automatic Job Management System 3 System Design (Work Tasks) Guide.

If the KAVU3217-W message was output before or after this message, an error occurred during the transfer processing for a result file. If 1 is set for the IgnoreResultFileError environment setting parameter, the return code of the job process is set for the return code of the job, and the job is placed into the Ended normally, Ended with warning, or Ended abnormally status depending on the final judgment. In addition, the result file is not re-sent, because termination of the job is preferred. Accordingly, you cannot use the Execution Result Details dialog box of JP1/AJS3 - View to view the contents of the standard error output file.

Because the result file for the job is not re-sent, the values set for the NotfyJobStateInterval and NotfyJobStateCount environment setting parameters will not be enabled. (These parameters specify the interval for resending the result file for the job and the number of times it is re-sent.)

For details about the IgnoreResultFileError environment setting parameter, see 2.3 Setting up the job execution environment in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 2.

(S)

Cancels the requested processing.

(O)

Use the integrated trace log to check whether a KAVUxxxx message was output before or after this message. If it was output, also see the explanation provided in that message. If no other KAVUxxxx message was output, or if a reason code other than that shown above was output, use the data collection tool to collect data, and then contact the system administrator.