KAVS4975-E
The preceding unit wait function cannot be used (scheduler-service-name). : maintenance-information-1 maintenance-information-2 maintenance-information-3 maintenance-information-4
A unit assigned a wait condition cannot be executed.
The probable causes are as follows:
-
The JP1/AJS3 database uses a compatible ISAM configuration
-
yes is not set for the PREWAITUSE environment setting parameter
Each unit you attempted to execute ends abnormally with the message KAVS4952-E.
- (S)
-
Places the unit with wait conditions in Ended abnormally status.
- (O)
-
If the JP1/AJS3 database uses a compatible ISAM configuration, migrate to the standard configuration by following the instructions in 8.5 Setup after upgrading from JP1/AJS2 - Manager to JP1/AJS3 - Manager in the Job Management Partner 1/Automatic Job Management System 3 System Design (Configuration) Guide.
If the database already uses the standard configuration, check the value of the PREWAITUSE environment setting parameter. For details about the environment setting parameters, see 2.2 Setting up the scheduler service environment in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 2.