KAVS1930-W
Could not connect with the queueless job execution agent (agent-name). Reconnection processing started. : maintenance-information
The queueless job execution agent indicated by agent-name could not be connected, so the re-connection processing started.
If this message is output, the probable causes are:
-
A network error has occurred (for example, the manager or agent host has not been connected to the LAN).
-
The agent host name cannot be resolved.
-
The load for the agent is high, so the connection request cannot be processed.
-
There was insufficient memory available.
-
The port number (jplajs2qlag) on the agent for queueless job execution has been set incorrectly.
-
The queueless job execution agent or the agent host itself has stopped.
- (S)
-
Performs reconnection processing to resend the request for execution, forcible termination, or confirmation, which failed to be sent previously. After this message is output, the system manages the agent as an error agent. The system queues requests to the error agent, and then performs the re-connection processing in the same order as requested.
Although the timeout period for re-connection processing depends on the OS, the maximum period for terminating re-connection processing is specified by the environment setting parameter (REQDAGTRECONNECTTIMEOUT) for which the timeout period of communication recovery processing is set.
The system attempts re-connection twice every 60 seconds, but if the connection cannot be recovered, the system outputs the following error messages in accordance with the processing request, and finally the request is terminated:
-
Job execution request : KAVS1931-E
-
Job forcible termination request : KAVS1932-E
-
Job confirmation request : KAVS1933-E
If reconnection is successful, the system outputs the KAVS1929-I message and then resends the queued requests in sequence to recover from the error.
-
- (O)
-
Check the logs for the manager host and the agent host, and the network status.
Remove the cause of the connection error.