KAVS1122-E

An attempt to read the pattern file used by the command failed, or an attempt to allocate memory while the file was being read failed.

(S)

Cancels command execution.

(O)

Check whether read or higher permission has been given for the file shown in the message. If the permission is not set, give read or higher permission for the file, and then re-execute the command.

For UNIX, see the Release Notes and make sure that the value of the kernel parameter for memory is greater than the estimated value.

If the file does not exist, contact the system administrator, and then collect data (see 1.2.3 To the system administrators).

The file shown in the message is stored in the following directory:

In Windows:

JP1/AJS3-installation-folder\conf

In UNIX:

/etc/opt/jp1ajs2/conf