KAVS0863-E

Interprocess communication failed due to one of the following:

• The JP1/AJS3 service has not started.

• The ajsinetd process at the connection destination has not started.

• An error occurred during communication with the JP1/Base event service.

You can use the jajs_spmd_status command to check whether the ajsinetd process has started. For details on the jajs_spmd_statsu command, see 2. Commands in the manual Job Management Partner 1/Automatic Job Management System 3 Command Reference 1.

(S)

Terminates processing if the JP1/AJS3 service or the ajsinetd process at the connection destination has not started.

If an errot occurred during communication with the JP1/Base event service, the system follows the specification of the EVENTRETRY environment setting parameter to output subsequent events, and continues processing.

If you specified yes for the EVENTRETRY environment setting parameter, the system connects to the JP1/Base event service to output the next events.

If you omitted the EVENTRETRY environment setting parameter or specified no for this parameter, the system blocks the output of events until the JP1/AJS3 service restarts.

(O)

Examine the cause of the error, and then re-execute the command.

If the JP1/AJS3 service at the connection destination has not started, start the appropriate service.

If the ajsinetd process has not started, execute the jajs_hstd command to start the process. For details on the jajs_hstd command, see jajs_hstd in 2. Commands in the manual Job Management Partner 1/Automatic Job Management System 3 Command Reference 1.

If the message "Failed to put Event." is displayed in maintenance-information-1 and you omitted the EVENTRETRY environment setting parameter or specified no for it, check the status of the JP1/Base event service, and then restart the JP1/AJS3 service.