4.2.2 Unit configuration definition
This paragraph explains how to specify a unit configuration definition.
The following gives the format of, and parameters for a unit configuration definition.
- Format
[el=unit-name, unit-type, +H +V;] [sz=lateral-icon-count-times-longitudinal-icon-count;]
- Parameters
-
- el=unit-name, unit-type, +H +V;
-
Specify the information for a unit.
-
unit-name: Specify a unit name.
You can specify a character string of 1 to 30 bytes.
-
unit-type: Specify a unit type.
For details about the unit type, see the ty parameter in 4.2.1 Attribute definition.
-
- +H
-
To display the icon of a unit in the JP1/AJS3 - View window, specify in pixels the horizontal location of the unit icon.
You can set 0 to 16,000 (pixels).
Use the formula below to determine the pixel value.
H = 80 + 160x (x: 0 to lateral icon count - 1)
If you set a value other than that determined from the formula, the system automatically sets a suitable value.
For a job group and a unit covered in the start conditions, H defaults to 0.
- +V
-
To display a unit in the JP1/AJS3 - View window, specify in pixels the vertical location of the unit icon.
You can set 0 to 10,000 (pixels).
Use the formula below to determine the pixel value.
V = 48 + 96y (y: 0 to longitudinal icon count - 1)
If you set a value other than that determined from the formula, the system automatically sets a suitable value.
For a job group and a unit covered in the start conditions, V defaults to 0.
- sz=lateral-icon-count-times-longitudinal-icon-count;
-
Define the maximum number of unit icons displayed in the JP1/AJS3 - View window. This is valid only for a jobnet and a remote jobnet.
-
lateral-icon-count: You can set 1 to 100. The default is 10.
-
longitudinal-icon-count: You can set 1 to 100. The default is 8.
-