jpqshmake (UNIX only)
- Organization of this page
Format
jpqshmake
[logical-host-name]
Description
Suppresses the increase of the number of segments in the shared memory, in either of the following cases:
-
When the jajs_killall.cluster command is executed when a JP1/AJS3 service starts
-
When the jpqagtdmn process ends abnormally when a JP1/AJS3 service starts
You only need to execute this command once after setup following an upgrade of JP1/AJS2 from version 06-71-/G or earlier. You do not need to execute this command for a new installation. For details, see 12.2.1(2)(c) About the shared memory used by job execution control (for upgrade installation from 06-71-G1 or an earlier version) in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 1.
Execution privileges
Superuser privileges
Arguments
logical-host-name
Specifies the name of a logical host in the logical host environment where JP1/AJS3 is started.
1 to 255 bytes can be specified.
Specify this argument only for the logical hosts in the cluster configuration.
Return values
|
0 |
Ends normally |
|
Values other than 0 |
Ends abnormally |