13.6 Operating an AJS3 unit monitored object
When a problem occurred in an AJS3 unit monitored object, you can perform only the following operations to directly use the monitored root jobnet from JP1/AJS3 Console View.
To perform these operations, the JP1 user that logs in must have the right to operate the monitored jobnets.
- Cautionary notes
-
-
To perform these operations, the JP1 user that logs in must have the right to operate the monitored jobnets.
-
You can operate only in the monitoring mode and while the monitor status is Now monitoring status.
-
You may not able to operate a monitored object depending on its status.
-
- Supplementary note
-
When a problem occurs in the status of the monitored application, you can start JP1/AJS3 - View from JP1/AJS3 Console View to check the cause. For details, see 13.7 Starting JP1/AJS3 - View.
- Organization of this section