5.2 Defining units

This section describes how to define a job group and define jobnets and jobs in the job group.

The following figure shows the Jobnet Editor window that you use to define units.

Figure 5‒1: Jobnet Editor window

By defining units in a unit definition file, you can execute the ajsdefine command to define units. For details of the command, see the description of ajsdefine in 2. Commands in the manual Job Management Partner 1/Automatic Job Management System 3 Command Reference 1.

Organization of this section

• 5.2.1 Defining job groups

• 5.2.2 Defining a jobnet

• 5.2.3 Defining jobs

• 5.2.4 Defining jobnet connectors

• 5.2.5 Relating jobs and jobnets

• 5.2.6 Assigning wait conditions

To Page Top