Job Management Partner 1 Version 10, Job Management Partner 1/Automatic Job Management System 3 Operator's Guide
![[Contents]](FIGURE/CONTENT.GIF)
![[Glossary]](FIGURE/GLOSS.GIF)
![[Index]](FIGURE/INDEX.GIF)
![[Back]](FIGURE/FRONT.GIF)
13.6 Operating an AJS3 unit monitored object
When a problem occurred in an AJS3 unit monitored object, you can perform only the following operations to directly use the monitored root jobnet from JP1/AJS3 Console View.
To perform these operations, the JP1 user that logs in must have the right to operate the monitored jobnets.
- Cautionary notes
- To perform these operations, the JP1 user that logs in must have the right to operate the monitored jobnets.
- You can operate only in the monitoring mode and while the monitor status is Now monitoring status.
- You may not able to operate a monitored object depending on its status.
- Supplementary note
- When a problem occurs in the status of the monitored application, you can start JP1/AJS3 - View from JP1/AJS3 Console View to check the cause. For details, see 13.7 Starting JP1/AJS3 - View.
- Organization of this section
- 13.6.1 Operation details
- 13.6.2 Operation procedure
Copyright (C) 2012, Hitachi, Ltd.
Copyright (C) 2012, Hitachi Solutions, Ltd.