Job Management Partner 1 Version 10, Job Management Partner 1/Automatic Job Management System 3 Operator's Guide
You can change the lightness of the colors used for units that are not base units, preceding units, or succeeding units when those units are highlighted in the map area in the Jobnet Monitor window. The same lightness level also applies to relation lines between units that are not base units and preceding and succeeding units.
The following table describes the lightness levels and their corresponding transparency.
Table 11-8 Lightness levels and corresponding transparency (highlighting)
Level | Transparency (%) | Remarks |
---|---|---|
0 | 0 | The unhighlighted units and relation lines are displayed in the normal manner, not in light hues. |
1 | 10 | -- |
2 | 20 | -- |
3 | 30 | -- |
4 | 40 | -- |
5 | 50 | -- |
6 | 60 | -- |
7 | 70 | -- |
8 | 80 | Default setting |
9 | 90 | -- |
10 | 100 | The unhighlighted units and relation lines are displayed in white (causing them to disappear). However, you can still select and perform operations (such as deletion) on units and relation lines, so be careful not to operate on them unknowingly or by mistake. |
Copyright (C) 2012, Hitachi, Ltd.
Copyright (C) 2012, Hitachi Solutions, Ltd.