Job Management Partner 1 Version 10, Job Management Partner 1/Automatic Job Management System 3 Operator's Guide
This section describes the operation for defining the Processing_Of_Received_Order jobnet.
Four major steps are required to define this jobnet.
Step 1: Define a job group.
Step 2: Define a jobnet.
Step 3: Define jobs.
Step 4: Relate jobs.
This section describes steps 2 to 4. Step 1 Define a job group is omitted here since we use the job group (AJSROOT1) that is automatically created when JP1/AJS3 - Manager is installed.
In the AJSROOT1 job group, define the Processing_Of_Received_Order jobnet.
To define the jobnet:
Figure 2-4 Define Details - [Jobnet] dialog box
Figure 2-5 JP1/AJS3 - View window (Main window) after the jobnet has been created
Define jobs in the Processing_Of_Received_Order jobnet.
To define jobs:
Figure 2-6 Jobnet Editor window before jobs have been defined
Figure 2-7 Define Details - [PC Job] dialog box (Definition page)
Figure 2-8 Define Details - [PC Job] dialog box (Attributes page)
Relate the four jobs as an execution order.
For this example, you relate the Job_CalculateReceivedOrderData job, the Job_CheckStock job, and the Job_CreateReceivedOrderSlip job in this order, which is the normal execution order of the jobs.
You then relate the Job_CheckStock job and the RecoverJob_CreateShippingSlip recovery job in this order. This order specifies that if the Job_CheckStock job ends abnormally, then the recovery job will be executed.
Perform the following procedure to relate the jobs.
To relate jobs:
Figure 2-9 Jobnet Editor window after jobs have been defined and related
Now the Processing_Of_Received_Order jobnet is completely defined.
You do not need to save a jobnet after it is defined since information is automatically saved each time any change is made, such as when a jobnet is created or a job is defined.
When you finish defining a jobnet, you can execute the jobnet. Close the Jobnet Editor window.
Copyright (C) 2012, Hitachi, Ltd.
Copyright (C) 2012, Hitachi Solutions, Ltd.