8.3.1 General procedure for registering a jobnet-definition release

The following is the general procedure for registering a jobnet-definition release.

1. Define the release-source jobnet.

   Copy a running root jobnet whose definition you want to change to any location, and define the copy as the release-source jobnet.

2. As required, perform a check of the release-source root jobnet definition.

   Use the ajschkdef command to pre-check the definition of the release-source root jobnet.

   Although you register a jobnet-definition release by specifying a release-source jobnet that does not have an execution schedule later than the release date, an execution schedule will not be created. Execute the ajsschedule command to check whether the release-source jobnet has an execution schedule later than the release date.

   For details about the ajschkdef command, see ajschkdef in 2. Commands in the manual Job Management Partner 1/Automatic Job Management System 3 Command Reference 1.

   For details about the ajsschedule command, see ajsschedule in 2. Commands in the manual Job Management Partner 1/Automatic Job Management System 3 Command Reference 1.

3. Register the release.

   You register a jobnet-definition release by specifying information such as the release date and release-target jobnet. For details about such registration, see 8.3.2 Registering a jobnet-definition release.

To Page Top