2.3.4 Recovering the JP1/AJS3 - Agent setup information
The following lists the tasks required to recover the JP1/AJS3 - Agent setup information of from the backup.
-
Setting up JP1/AJS3
-
Recovering the definition files
-
Starting JP1/AJS3 (cold start)
The following describes the tasks required to recover the JP1/AJS3 - Agent setup information from the backup.
- Organization of this subsection
(1) Setting up JP1/AJS3
If the JP1 environment has been damaged due to a corrupted disk or another problem, you must install JP1/Base, set up JP1/Base, and then install the JP1/AJS3 series program in that order. For details about how to set up JP1/AJS3 - Agent, see 3.2.2 Setting up JP1/AJS3 - Agent in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 1 (in Windows) or 13.2.2 Setting up JP1/AJS3 - Agent in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 1 (in UNIX).
(2) Recovering the definition files
Restore the backed-up files to their original locations.
- Cautionary note
-
Before you recover the definition files, make sure that the following conditions exist:
-
JP1/Base is installed.
-
JP1/AJS3 is installed.
-
JP1 in the logical host environment has been set up (for recovery of a logical host environment).
-
JP1/Base and JP1/AJS3 are not running.
-
The shared disk is mounted (to recover the settings file of a logical host).
-
(3) Starting JP1/AJS3
After recovery, cold-start JP1/AJS3.