18.3 Setting up JP1/AJS3 - Agent

This section describes how to set up JP1/AJS3 - Agent to enable disaster recovery operation.

When the main site and the remote site share JP1/AJS3 - Agent:

Make sure that setup of a JP1/AJS3 - Agent environment has been completed.

Cautionary note:

If the IP addresses of the main-site and remote-site logical hosts are different, make sure that the following conditions are also met:

The agent host can communicate with the manager hosts on both the main and remote sites.
(If the setting to restrict connections to JP1/AJS3 is enabled) The IP addresses of the manager hosts on both the main and remote sites are set in the agent connection permission configuration file.

When the main site and the remote site do not share JP1/AJS3 - Agent:

Make sure that setup of a JP1/AJS3 - Agent environment has been completed.