15.3.15 Setting the connection timeout for communication between the event/action control manager and agent

When an event job or a jobnet with start conditions is executed, the event/action control manager and the event/action control agent communicate with each other. At this time, waiting for a connection by the manager or the agent might result in a timeout depending on the state of the communication environment, such as a busy network. If such timeouts are frequent, repeated retries might delay the execution of event jobs or jobnets with start conditions or delay the detection of monitored events. For such situations, you can adjust the timeout value by using the environment setting parameter described in (2) below.

Use the procedure below for setting the environment setting parameter.

Organization of this subsection

(1) Definition procedure
(2) Environment setting parameter

(1) Definition procedure

Stop the JP1/AJS3 service.

Execute the following commands to confirm that all processes have stopped:
```
# /etc/opt/jp1ajs2/jajs_stop^#1
# /opt/jp1ajs2/bin/jajs_spmd_status
```
#1:

Confirm that automatic termination has been set.
Execute the following command to set the environment setting parameter described in (2) below:
```
jajs_config -k definition-key "parameter-name"=value
```
Restart JP1/AJS3.

The new settings are applied.

To Page Top

(2) Environment setting parameter

Table 15‒52: Environment setting parameter for the connection timeout between the event/action control manager and agent
Definition key	Environment setting parameter	Explanation
Event action control manager For all scheduler services `[{JP1_DEFAULT\|logical-host}\JP1AJS2\HOST\NETWORK\EVMANAGER]`^# For a specific scheduler service `[{JP1_DEFAULT\|logical-host}\JP1AJSMANAGER\scheduler-service\NETWORK\EVMANAGER]`^# Event action control agent `[{JP1_DEFAULT\|logical-host}\JP1AOMAGENT]`^#	"`ClientConnectTimeout"=`	Connection timeout between the event/action control manager and agent

#:: The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.

For details about defining the environment setting parameters for the event/action control manager, see the following:

2.6.2(1) ClientConnectTimeout in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 2

For details about defining the environment setting parameters for the event/action control agent, see the following:

2.4.2(23) ClientConnectTimeout in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 2

To Page Top