15.3.6 Resuming event jobs that stopped when the JP1/AJS3 service stopped

For event jobs, JP1/AJS3 provides an option that enables event jobs that have stopped when the JP1/AJS3 service stopped to resume in the same status from the point at which they stopped.

The following describes how to enable this option. For details about the functionality of this option, see 9.2.1 Continuing the execution of event jobs if the JP1/AJS3 service stops in the Job Management Partner 1/Automatic Job Management System 3 Administration Guide.

Organization of this subsection

(1) Definition procedure
(2) Environment setting parameter

(1) Definition procedure

(a) For a standard configuration

Stop the JP1/AJS3 service.

Execute the following commands to confirm that all processes have stopped:
```
# /etc/opt/jp1ajs2/jajs_stop^#1
# /opt/jp1ajs2/bin/jajs_spmd_status
```
#1:

Confirm that automatic termination has been set.
Execute the following command to set the environment setting parameter described in (2) below:
```
jajs_config -k definition-key "parameter-name"=value
```
Restart JP1/AJS3.

The new settings are applied.

(b) For a compatible ISAM configuration

Stop the JP1/AJS3 service.

Execute the following commands to confirm that all processes have stopped:
```
# /etc/opt/jp1ajs2/jajs_stop^#1
# /opt/jp1ajs2/bin/jajs_spmd_status
```
#1:

Confirm that automatic termination has been set.
In an editor such as vi, create a configuration file that defines the environment setting parameter described in (2) below.
Save the file and then execute the following command:
```
jbssetcnf configuration-file-name
```
The path of the jbssetcnf command is /opt/jp1base/bin/jbssetcnf. For details on this command, see the Job Management Partner 1/Base User's Guide.
Restart JP1/AJS3.

The contents of the configuration file are applied to the system.

To Page Top

(2) Environment setting parameter

Table 15‒43: Environment setting parameter used to enable event jobs that have stopped when the JP1/AJS3 service stopped to resume
Definition key	Environment setting parameter	Explanation
For all scheduler services `[{JP1_DEFAULT\|logical-host}\JP1AJS2\SCHEDULER\EV\MANAGER]`^# For a specific scheduler service `[{JP1_DEFAULT\|logical-host}\JP1AJSMANAGER\scheduler-service\EV\MANAGER]`^# For a compatible ISAM configuration `[{JP1_DEFAULT\|logical-host}\JP1AOMMANAGER]`^#	`"EvJobExecContinue"=`	Specifies whether to enable the execution of stopped event jobs to resume.

#:: The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.

For details about the definition of this environment setting parameter, see 2.4.2(7) EvJobExecContinue in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 2.

To Page Top