15.3.3 Setting the status passing option for the file monitoring job

While the file monitoring job is monitoring target files, the monitoring information can be saved continuously so that the monitoring status of the job can be inherited if the JP1/AJS3 service temporarily stops.

Note that the monitoring status can be inherited only if the file monitoring job is operating continuously. Whether the monitoring status can be inherited depends on whether the file monitoring job is operating continuously.

For details about the conditions under which the monitoring status can be inherited, see 7.6.2 Notes on the Monitoring Files job in the Job Management Partner 1/Automatic Job Management System 3 System Design (Work Tasks) Guide.

The function that inherits the monitoring status of the file monitoring job is disabled by default. Note, however, that the function is enabled when JP1/AJS3 is installed as a new installation and set up. The following describes how to set the status passing option.

Organization of this subsection

(1) Definition procedure
(2) Environment setting parameter

(1) Definition procedure

(a) For a standard configuration

Stop the JP1/AJS3 service.

Execute the following commands to confirm that all processes have stopped:
```
# /etc/opt/jp1ajs2/jajs_stop^#1
# /opt/jp1ajs2/bin/jajs_spmd_status
```
#1:

Confirm that automatic termination has been set.
Execute the following command to set the environment setting parameter described in (2) below:
```
jajs_config -k definition-key "parameter-name"=value
```
Restart JP1/AJS3.

The new settings are applied.

(b) For a compatible ISAM configuration

Stop the JP1/AJS3 service.

Execute the following commands to confirm that all processes have stopped:
```
# /etc/opt/jp1ajs2/jajs_stop^#1
# /opt/jp1ajs2/bin/jajs_spmd_status
```
#1:

Confirm that automatic termination has been set.
In an editor such as vi, create a configuration file that defines the environment setting parameter described in (2) below.
Save the file and then execute the following command:
```
jbssetcnf configuration-file-name
```
The path of the jbssetcnf command is /opt/jp1base/bin/jbssetcnf. For details on this command, see the Job Management Partner 1/Base User's Guide.
Restart JP1/AJS3.

The contents of the configuration file are applied to the system.

To Page Top

(2) Environment setting parameter

Table 15‒40: Environment setting parameter used to set the status passing option for the file monitoring job
Definition key	Environment setting parameter	Explanation
`[{JP1_DEFAULT\|logical-host}\JP1AOMAGENT]`^#	`"FilewatchinfContinue"=`	Specifies whether the status passing option for the file monitoring job is enabled.

#:: The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.

For details about the definition of this environment setting parameter, see 2.4.2(18) FilewatchinfContinue in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 2.

To Page Top