13.1.2 Setting up JP1/AJS3 - Manager

This subsection describes how to set up JP1/AJS3 - Manager. Before you set up JP1/AJS3 - Manager, make sure that you have logged in as superuser.

After you have set up JP1/Base, set up JP1/AJS3 - Manager. Make sure that the umask for the user who starts JP1/AJS3 permits viewing and updating by any user who executes JP1/AJS3 commands.

Note that this subsection describes the basic setup of JP1/AJS3. If you need to change the settings to match specific operating requirements, see the appropriate section listed in the following table.

Topic	Reference
Procedure for setting the execution agent	14.1
Procedure for setting environment setting parameters	14.2
Procedure for setting up operation profiles	14.3
Procedure for restricting connections to JP1/AJS3	14.4
Settings for controlling the scheduler	15.1
Settings for controlling job execution	15.2
Settings for controlling events and actions	15.3
Settings for controlling queueless job execution	15.4
Settings for the definition pre-check function	15.5
Settings common to all control processes	15.6
Other settings	15.7
Settings for logging	16
Setting up a cluster system	17
Setup for disaster recovery operations	18

Organization of this subsection

(1) Setup procedure

(1) Setup procedure

To set up JP1/AJS3 - Manager:

If necessary, change the environment setting parameters.

Skip this step if you accept the environment setting parameter values proposed by JP1/AJS3. To change environment setting parameter values, use the jajs_config command, or the jbssetcnf command provided by JP1/Base.

For details about how to set the environment setting parameters, see 14.2 Environment setting parameter settings.
Set up the system and user environments.

For details about setting up the system and user environments, see 13.4 Setting up the system and user environments.
If necessary, set automatic startup and termination of the JP1/AJS3 service.

For details about setting automatic startup and termination of the JP1/AJS3 service, see 15.7.1 Setting automatic startup and termination of the JP1/AJS3 service.

JP1/AJS3 - Manager setup is complete.

To Page Top