12.1.1 Installing JP1/Base
Make sure that JP1/Base has been installed on the hosts on which JP1/AJS3 - Manager will be installed.
Note that if you select automatic setup when performing a new installation of JP1/Base, the following user information is automatically set. If this information is appropriate, you do not need to set any user information.
-
Authentication server: local host
-
JP1 user: jp1admin
-
JP1 user's password: jp1admin
-
OS user mapped to the JP1 user: root
-
Server host name: *
If automatic setup is not selected during a new installation of JP1/Base or if JP1/Base is remotely installed as a new installation by using JP1/Software Distribution, the authentication server and JP1 user settings are not specified automatically. In such cases, these settings must be specified manually after JP1/Base has been installed. If the authentication server for JP1/Base has not been set, startup of the JP1/AJS3 service in JP1/AJS3 - Manager fails.
For details about installing and setting up JP1/Base, see the Job Management Partner 1/Base User's Guide.