9.3 Setting up JP1/AJS3 - Agent
This section describes how to set up JP1/AJS3 - Agent to enable disaster recovery operation.
- When the main site and the remote site share JP1/AJS3 - Agent:
-
Make sure that setup of a JP1/AJS3 - Agent environment has been completed.
- Cautionary note:
-
If the IP addresses of the main-site and remote-site logical hosts are different, make sure that the following conditions are also met:
-
The agent host can communicate with the manager hosts on both the main and remote sites.
-
(If the setting to restrict connections to JP1/AJS3 is enabled) The IP addresses of the manager hosts on both the main and remote sites are set in the agent connection permission configuration file.
-
- When the main site and the remote site do not share JP1/AJS3 - Agent:
-
Make sure that setup of a JP1/AJS3 - Agent environment has been completed.