6.2.23 Settings for re-executing the dependent units
This subsection describes how to configure the settings for re-executing dependent units. For details about how to re-execute dependent units, see 4.5.11(4) Re-executing the dependent unit of a judgment job in the manual Job Management Partner 1/Automatic Job Management System 3 Overview.
- Organization of this subsection
(1) Definition procedure
-
In Windows Control Panel, open the Services administrative tool, and stop the following service:
-
JP1/AJS3 service
- Cautionary note:
-
In a cluster system, check the cluster settings, and also stop the JP1/AJS3 service on each logical host.
-
-
Execute the following command to set the environment setting parameter described in (2) below:
jajs_config -k definition-key "parameter-name"=value
-
Restart JP1/AJS3.
The new settings are applied to the configuration definition.
(2) Environment setting parameter
Definition key |
Environment setting parameter |
Explanation |
---|---|---|
[{JP1_DEFAULT|logical-host}\JP1AJSMANAGER\scheduler-service]# |
"RERUNSUBORDINATE"= |
Specifies whether dependent units are to be re-executed. |
- #:
-
The specification of the {JP1_DEFAULT|logical-host} part depends on whether the host is a physical host or a logical host. For a physical host, specify JP1_DEFAULT. For a logical host, specify the logical host name.
For details about the definition of this environment setting parameter, see 2.2.2(104) RERUNSUBORDINATE in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 2.