6.1.4 Changing the name of a scheduler trace log file
The default trace log file name for the scheduler service is as follows:
- For Windows Server 2012 or Windows Server 2008, if the installation folder is in the default folder or a folder protected by the system:
-
%ALLUSERSPROFILE%\Hitachi\JP1\JP1_DEFAULT\JP1AJS2\log\tracelog
The default %ALLUSERSPROFILE% value is system-drive\ProgramData.
A folder protected by the system is the path to a folder in any of the following:
- system-drive\Windows
- system-drive\Program Files
- system-drive\Program Files (x86) (for 64-bit Windows)
- For Windows Server 2012 or Windows Server 2008 in which an installation folder other than the above is used:
-
JP1/AJS3-Manager-installation-folder\log\tracelog
- For Windows Server 2003:
-
JP1/AJS3-Manager-installation-folder\log\tracelog
You can change the name of a scheduler trace log file by using the following procedure.
- Organization of this subsection
(1) Definition procedure
-
In Windows Control Panel, open the Services administrative tool, and stop the following service:
-
JP1/AJS3 service
-
-
Execute the following command to set the environment setting parameter described in (2) below:
jajs_config -k definition-key "parameter-name"=value
-
Restart JP1/AJS3.
The new settings are applied to the configuration definition.
(2) Environment setting parameter
|
Definition key |
Environment setting parameter |
Explanation |
|---|---|---|
|
[JP1_DEFAULT\JP1AJSMANAGER] |
"TRACELOGFILE"=# |
Specifies the name of a scheduler trace log file. |
- #:
-
The scheduler trace information for the physical host and all logical hosts is recorded in the file specified by this parameter. To ensure that the trace information is recorded, always specify the name of a file on a local disk.
Note that the specified file is created when trace information is output. Do not specify the name of an existing file.
For details about the definition of this environment setting parameter, see 2.2.2(3) TRACELOGFILE in the Job Management Partner 1/Automatic Job Management System 3 Configuration Guide 2.