3.1.2 Setting up JP1/AJS3 - Manager
This subsection describes how to set up JP1/AJS3 - Manager. Before you set up JP1/AJS3 - Manager, make sure that you have logged on as a member of the Administrators group.
Also make sure that JP1/Base has already been set up before you attempt to set up JP1/AJS3 - Manager.
Note that this subsection describes the basic setup of JP1/AJS3. If you need to change the settings to match specific operating requirements, see the appropriate section listed in the following table.
Topic |
Reference |
---|---|
Procedure for setting the execution agent |
|
Procedure for setting environment setting parameters |
|
Procedure for setting up operation profiles |
|
Procedure for restricting connections to JP1/AJS3 |
|
Settings for controlling the scheduler |
|
Settings for controlling job execution |
|
Settings for controlling events and actions |
|
Settings for controlling queueless job execution |
|
Settings for the definition pre-check function |
|
Other settings |
|
Settings for logging |
|
Setting up a cluster system |
|
Setup for disaster recovery operations |
- Organization of this subsection
(1) Setup procedure
To set up JP1/AJS3 - Manager:
-
If necessary, change the account settings for the JP1/AJS3 service.
Skip this step if it is not necessary to change the account settings for the JP1/AJS3 service. For details about the operation required to change the account settings, see 4.2.3(1) Changing the account for services provided by JP1/AJS3 in the Job Management Partner 1/Automatic Job Management System 3 System Design (Configuration) Guide.
-
If necessary, change the environment setting parameters.
Skip this step if you accept the environment setting parameter values proposed by JP1/AJS3. To change environment setting parameter values, use the jajs_config command, or the jbssetcnf command provided by JP1/Base.
For details about how to set the environment setting parameters, see 4.2 Environment setting parameter settings.
-
If necessary, set up the system and user environments.
For details about setting up the system and user environments, see 3.5 Setting up the system and user environments.
JP1/AJS3 - Manager setup is complete.