7.3.1 Updating statuses
Immediately after you log in, or immediately after you switch from Definition mode to Monitoring mode, the icon of each AJS3 unit monitored object is displayed in a color indicating that no status is available for the object. JP1/AJS3 Console View then begins to obtain status levels for each AJS3 unit monitored object, and updates the display to reflect the status levels as they are received.
When the status level of a monitored object is updated, there will be a time lag before the color of the AJS3 unit monitored object in the business scope is updated to reflect the change. The maximum length of the time lag is equivalent to the monitoring interval that you set for the monitoring method under monitoring properties (the default is 300 seconds).
You can update the status levels in JP1/AJS3 Console View at any time by choosing View, and then Refresh.
- Supplementary note
-
The Refresh command is not supported if you log in to JP1/AJS2 Console Manager from JP1/AJS2 Console 06-71. If the host on which the monitored application is defined is running JP1/AJS2 - Manager version 06-71 or earlier, the status levels remain unchanged when you choose Refresh.