5.4.11 Stopping JP1/AJS3 services and job execution control
When stopping JP1/AJS3 services, you can either kill active jobs or wait for them to terminate. The default stop method is to kill active jobs.
- Kill active jobs and stop JP1/AJS3 services
-
In this method, job execution control kills active jobs and then stops the JP1/AJS3 services. Jobs running on other agent hosts are not affected.
- Stop JP1/AJS3 services after active jobs terminate
-
In this method, job execution control waits until all jobs including those running on other agent hosts have terminated, and then stops the JP1/AJS3 services.
For details on how to stop JP1/AJS3 services, see 7.1.2 Stopping JP1/AJS3 services manually in the Job Management Partner 1/Automatic Job Management System 3 Administration Guide. For details on forced termination by job execution control, see 5.4.10 Killing jobs.
You can temporarily change the method used to stop JP1/AJS3 services by specifying the required option in the jajs_spmd_stop command arguments. For details, see 7.2.2 Temporarily changing the end mode of JP1/AJS3 in the Job Management Partner 1/Automatic Job Management System 3 Administration Guide.