8.2 Notes on using the commands

This section provides a list of notes when you use the commands.

• You must open a command prompt as an administrator if you want to execute any command that requires Administrator permissions on a Windows Server 2008 host. You can open a command prompt as an administrator by right-clicking Command Prompt in the Start menu of Windows and then selecting Run as administrator. However, if the User Account Control (UAC) feature is disabled, you do not have to open a command prompt as the administrator.
• If you enable the QuickEdit mode in the command prompt window, clicking the command prompt window suspends the window output until you resume the output. For this reason, we recommend that you do not use the QuickEdit mode.
• If you want to use a command in a cluster environment, run the command in the executing host.
• If you want to suspend the execution of a command, press the Ctrl + C keys. After the command is suspended, check the suspension message for any problem. If you want to resume the command, then execute it again.
• Do not press the Ctrl + S keys while a command is being executed. If you do so, the command output is stopped.
• You cannot execute any commands other than the submittask and stoptask commands with other JP1/AO commands at the same time.
• You might get a return value other than 2 (The command execution has been interrupted) depending on the type of the command when you interrupt the command immediately after its execution.
• You can execute a maximum 10 instances of the submittask command and a maximum of 10 instances of the stoptask commands concurrently. If you attempt to execute the 11th instance, the following message appears and the task is not executed:
  KNAE03236-E No more commands can be executed at the moment. Wait until one or more currently executing commands end, and then try again.
  
• When you execute the following commands, you can change the subject identification information that will be output to the audit log by changing the property file settings:
  
  • deleteservicetemplate command
  • importservicetemplate command
  • listservices command
  • listtasks command
  • stoptask command
  • submittask command

Related topic

• Topic Properties file (config_user.properties) in the Job Management Partner 1/Automatic Operation Configuration Guide