7.4.16 Specify Plug-in Output Properties for Mapping dialog box

Use the Specify Plug-in Output Properties for Mapping dialog box to set a mapping parameter for an output property. To display the Specify Plug-in Output Properties for Mapping dialog box, in the Create Step dialog box or in the Edit Step dialog box, click the Edit button in the Output Properties section.

Figure 7-49 Specify Plug-in Output Properties for Mapping dialog box

This dialog box displays the following items:

Key

Shows the property key of the output property.

Name

Shows the name of the output property.

Description

Shows a brief description of the output property.

Mapping Parameter

Shows the service property key that has been mapped.

Service Properties

Displays a list of service properties that can be used for mapping to the output property. If you click a service property, the property is specified as the mapping parameter. If you click the column title of a display item, the data will be sorted in ascending or descending order.

Table 7-31 Items displayed in Service Properties (Specify Plug-in Output Properties for Mapping dialog box)

Display item	Description
Key	Displays the property key of each property.
Name	Displays the name of each property.
Description	Displays a brief description of each property.

Add Output Property button

Click this button to add an output property. The Create Output Property for Service dialog box appears.

Add Variable button

Click this button to add a variable. The Create Variable dialog box appears.

OK button

Click this button to set the mapping parameter for the output property.

Cancel button

Click this button to close the Specify Plug-in Output Properties for Mapping dialog box.