8.4.5 Procedure to configure JP1/Base (cluster system)
Configure JP1/Base.
To configure JP1/Base:
-
On both the active and standby servers, if you want to use JP1/Base as the physical host, change the communication binding method to the ANY binding method.
- Important note
-
If Common Component and JP1/AO are on different servers, a warning message is output when an attempt to delete authentication data fails during the uninstallation. In this case, after confirming that Common Component is running, delete the authentication data by executing the hcmdsintg command.
Related topics
-
Changing communication settings in the Job Management Partner 1/Base User's Guide