4.5.2 Procedure to change the IP address of the JP1/AO server (cluster system)

To change the IP address of the JP1/AO server, you must bring the resource group offline where the JP1/AO service is registered and stop the service.

The procedure to change the IP address is the same for both IPv4 and IPv6.

Before you begin

Log in to the JP1/AO server as a domain user with Administrator permissions on the OS and administrator permissions on the cluster.

To change the IP address of the JP1/AO server:

1. In the Tasks window, check the tasks. If any tasks are in the execution status (In Progress, Waiting for Response, Abnormal Detection, or Terminated), stop execution of the tasks or wait until the task status changes to the ended status.

2. On the active server, use the cluster software to bring the resource group offline where the JP1/AO service is registered.

3. Change the IP address of the JP1/AO server

4. On the active server, use the cluster software to bring the resource group online where the JP1/AO service is registered.

To Page Top