3.1.2 Procedure for setting up the configuration file for external authentication server linkage
Set up the configuration file for external authentication server linkage in order to access the JP1/Base authentication function.
To use the JP1/Base authentication function, you also need to create and configure JP1 users. Before or after the steps below, create and configure the JP1 users that will be managed by the JP1/Base authentication function.
In a cluster system, make the settings the same on both the active server and the standby server.
To link to the JP1/Base authentication function:
-
Open the configuration file for external authentication server linkage (exauth.properties).
This file is stored in the following folder:
Common-Component-installation-folder\conf
-
Specify the value jp1base for the specification key auth.server.type.
-
Save the changes to the configuration file for external authentication server linkage.
Related topics