KNAS91025-E
Access to a database went wrong.
- Description
-
An attempt to access the database failed.
- (S)
-
Stops the command.
- (O)
-
Check and, if necessary, revise the command arguments, and then re-execute the command. If the problem reoccurs, take the following corrective action.
- If execution of the command was suspended before this message was output:
-
Wait while database rollback processing executes, and then retry the operation.
- Otherwise:
-
Check whether the KFPH22025-E or KFPH22026-E message was output to the event log. If such a message was output, there is not enough space in the database. Extend the database area and execute setup again.
If such a message was not output, collect data and contact a system administrator.
For details about collecting data, see 7.1.6 Collecting the data needed for determining the cause of a problem.