6.2.10 Registering the Windows services into the cluster software
You register the Windows services for ITSLM - Manager and ITSLM - UR into the cluster software.
- Organization of this subsection
(1) Before you start
-
Verify that your user account belongs to the OS's Administrators group.
-
If at the time you register the Windows services into the cluster software you set the order in which the Windows services are to be started, use the order shown in the table below.
-
Windows services for ITSLM - Manager
No.
Windows service
Dependency
Displayed name
Service name
1
JP1/Base Event logical-host-name#1
JP1_Base_Eventlogical-host-name#1
-
Logical IP address used by JP1/Base
-
Shared disk used by JP1/Base
2
JP1/Base logical-host-name#1
JP1_Base_logical-host-name#1
Windows service for 1
3
JP1/ITSLM - Manager DB Service#2
HiRDBEmbeddedEdition_JL0
-
Logical IP address used by ITSLM - Manager
-
Shared disk used by ITSLM - Manager
4
JP1/ITSLM - Manager DB Cluster Service#2
HiRDBClusterService_JL0
Windows service for 3
5
JP1/ITSLM - Manager Service
JP1_ITSLM_MGR_Service
Windows service for 4
6
JP1/ITSLM - Manager Web Service#3
JP1_ITSLM_MGR_Web_Service
Windows service for 5
- #1
-
logical-host-name is the logical host name specified when JP1/Base is run in the cluster system.
- #2
-
If the cluster software is set so that, before failover is performed after the Windows service has stopped, starting the Windows services is retried on the same physical host, set the cluster software to fail over without retrying starting the Windows services.
- #3
-
After you have registered the Windows service, perform the operations listed below, based on the OS you are using.
If the OS is Windows Server 2008 R2:
Open a command prompt with Administrators permissions, and then execute the following command:
Cluster res "JP1/ITSLM - Manager Web Service" /priv StartupParameters=""
If the OS is Windows Server 2012:
Execute PowerShell in the command prompt, and then execute the following command:
Get-ClusterResource "JP1/ITSLM - Manager Web Service" | Set-ClusterParameter -Name StartupParameters -value ""
After executing the command, display the Properties dialog box for JP1/ITSLM - Manager Web Service to verify that the startup parameter value is blank on the General tab.
-
-
Windows services for ITSLM - UR
No.
Windows service
Dependency
Displayed name
Service name
1
JP1/ITSLM - UR Response Service
JP1_ITSLM_UR_Service
-
Logical IP address used by ITSLM - UR
-
Shared disk used by ITSLM - UR
-
-
-
If you have configured the ITSLM - Manager and ITSLM - UR environments on the same logical host, set the cluster service to start ITSLM - Manager first and then start ITSLM - UR.
(2) Procedure
For details about how to register the Windows services into the cluster software, see the applicable cluster software documentation.