KNAN21404-E
There is a host for which IM configuration synchronization failed.
Take action according to the manual, and then retry IM configuration synchronization.
Host where acquisition of the agent configuration failed. (Host: host-name)
Host where acquisition of the remote configuration failed. (Host: host-name)
Synchronization failed.
- S:
-
Stops synchronization.
- O:
-
Check whether JP1/Base is running on the host (site manager) for which an attempt to acquire an agent configuration failed. If it is running, perform the following.
Execute the jbsrt_get command.
Check whether any of the following occurred:
-
Was a KAVB3162-E message output?
-
Did the jbsrt_get command end abnormally?
-
Is the local host name displayed as a higher-level host or a lower-level host?
-
Is a host name other than the local host name displayed as the local host?
-
Is the host name misspelled?
If any of the above occurred, use the following method to recover from the error:
-
Execute the jbsrt_del command to delete the IM configuration.
-
Apply the IM configuration again from the manager host.
Check the following items for the host (site manager) for which an attempt to acquire a remote monitoring configuration failed.
-
Make sure that IM Configuration Management is running on the site manager. If a remote monitoring configuration does not exist on the site manager, ignore this message.
-
Connect IM Configuration Management - View and make sure that the remote monitoring configuration can be displayed.
-