KAVB3107-E
Cannot set configuration in the host. host-name
Configuration information could not be set in certain hosts during configuration definition confirmation.
- S:
-
Places the jbsrt_distrib command in error status.
- O:
-
On the host that has the error, check the following items:
-
Is JP1/Base running?
-
Is the same port number being used as the one specified for the Configuration Management instance of the host where the definitions are distributed?
-
Are lower-level hosts defined in JP1/Base?
-
Is JP1/IM - Satellite Console the higher-level host of JP1/IM - Manager?
-
Are at least 6 hosts defined immediately underneath JP1/IM - Central Console 5 Node?
-
Are at least 11 hosts defined immediately underneath JP1/IM - Central Console 10 Node?
-
Is it possible to resolve the host name of the host that has the error from a host at a higher-level than the host that has the error?
-
Was the host that has the error previously defined as the highest-level host? If the configuration definition information for the highest-level host remains, execute the jbsrt_distrib command to delete the configuration information.
-
After JP1/IM was installed, was JP1/Base restarted?
-
Has a memory shortage occurred?
-
Are there write and read permissions for the conf/route/ directory?
If the problem is other than the above, check the following items in the host that has the error:
-
Execute the jbsrt_get command.
-
Determine whether any of the following occurred:
Was a KAVB3162-E message output?
Did the jbsrt_get command end abnormally?
Is the local host name displayed as a higher-level host or a lower-level host?
Is a host name other than the local host name displayed as the local host?
Is the host name misspelled?
If any of the above occurred, use the following method to recover from the error:
-
Execute the jbsrt_del command to delete the configuration definition information.
-
On the manager host, execute the jbsrt_distrib command to redistribute the configuration definition information.
-