9.3.5 Configuring BJEX or JP1/AS
This section describes how to configure BJEX or JP1/AS when linking with JP1/IM - Manager.
- Organization of this subsection
(1) Specifying the link-target JP1/IM - Manager
BJEX and JP1/AS can link with one JP1/IM - Manager host, which you must specify in the appropriate configuration file. To specify the link-target JP1/IM - Manager host for BJEX, specify the JP1/IM - Manager host name in the BJEX configuration file (bjex.conf). To specify the link-target host for JP1/AS, specify the host name in the JP1/AS environment file.
(2) Setting the maximum number of response-waiting events
You can set the maximum number of response-waiting events that BJEX or JP1/AS can issue. Because the maximum number of events that can be in the hold-and-accumulate state is 2,000, estimate the number of response-waiting events so that the result of the following equation is 2,000 or less:
Total value of USERREPLY_WAIT_MAXCOUNT parameter across all hosts that output response-waiting events + Maximum number of response-waiting events output by all other products
You can set the maximum number of response-waiting events that BJEX can issue in the BJEX configuration file (bjex.conf). For JP1/AS, you can set this value in the JP1/AS environment file.