7.2.3 Example 3 (cluster operation with JP1/IM - View connection)
In this example, the manager is run in a cluster operation system, and is connected to two LANs that cannot be mutually routed, and JP1/IM - View is connected from each LAN.
The following tables show the settings for each host.
Host name |
Binding method |
jp1host setting |
---|---|---|
HostX (physical host) |
send ANY, receive IP |
10.1.1.2, 20.1.1.2 |
HostY (physical host) |
send ANY, receive IP |
10.1.1.3, 20.1.1.3 |
HostL (logical host) |
send ANY, receive IP |
10.1.1.11, 20.1.1.11 |
Note that you need JP1/Base communication settings. For details of the settings, see the chapter that describes JP1/Base communication settings depending on the network configuration in the Job Management Partner 1/Base User's Guide.
Host name |
Host to connect |
Other conditions |
Correspondence to number in parentheses in figure |
---|---|---|---|
HostA |
HostX |
Conversion from host name HostX to 10.1.1.2 must be possible. |
1 |
HostY |
Conversion from host name HostY to 10.1.1.3 must be possible. |
2 |
|
HostL |
Conversion from host name HostL to 10.1.1.11 must be possible. |
3 |
|
HostB |
HostX |
Conversion from host name HostX to 20.1.1.1 must be possible. |
4 |
HostY |
Conversion from host name HostY to 20.1.1.2 must be possible. |
5 |
|
HostL |
Conversion from host name HostL to 20.1.1.11 must be possible. |
6 |