2.18.1 Executing the setup program
To execute the setup program after you have installed JP1/IM - Manager:
-
Execute the setup program.
-
/opt/jp1cons/bin/jp1cc_setup
-
/opt/jp1scope/bin/jp1cs_setup
-
/opt/jp1imm/bin/imcf/jp1cf_setup
-
Depending on the installation status, execution of the setup program may not be required, as explained below.
-
When execution of the setup program is required
JP1/Base was uninstalled and then reinstalled.
-
When execution of the setup program is not required
A new installation of JP1/IM - Manager was performed.
The same version of JP1/IM - Manager was installed by overwriting.