2.9.4 Notes about setting the configuration definition information
When configuration definition information is distributed, JP1/Base must be running at each host. This subsection describes the effects when JP1/Base is inactive, and the actions to be taken.
-
Effects of inactive JP1/Base
Configuration definition information is managed by JP1/Base. If JP1/Base is not running at a host that is defined in the configuration definition information, distribution of configuration definition information will fail. In such a case, take the following actions:
-
Continue processing even if the message KAVB3107-E is displayed when the jbsrt_distrib command executes.
The configuration definition information will be distributed to the hosts where JP1/Base is running.
-
Start JP1/Base at the host where definition was not distributed, and then execute the jbsrt_distrib command again.
-
-
Effects of inactive JP1/Base Event Service
The configuration definition information is related to JP1 event forwarding. When the jbsrt_distrib or jbsrt_del command is executed, the jevreload command executes automatically and the Event Service's forwarding settings are updated (reloaded). If Event Service is not running during this reload processing, configuration definition information will be distributed, but the JP1 event destination information will not be updated. Restart Event Service.
For details about the configuration definition information, see the Job Management Partner 1/Base User's Guide.