1.6 Setting the startup sequence for services
To use the startup control service in JP1/Base to set the startup sequence for the JP1 services:
-
Specify the startup sequence control settings.
Normally, there is no problem with the default settings, but you must customize the settings in the following cases:
-
JP1/Power Monitor is being used to manage starting and stopping.
-
The IM database is being used.
-
For details about the settings, see the chapter that describes the settings for the service startup and stop sequences in the Job Management Partner 1/Base User's Guide. For details about how to start the IM database, see 3.1 Starting JP1/IM - Manager in the Job Management Partner 1/Integrated Management - Manager Administration Guide.