5.1 Checking the status of previously-issued events

After a given period of monitoring, error-related events that were issued previously might be issued again. Even if you want to check the corrective action you took in the past for such an event, the event might no longer be displayed in the event list.

In this section, we will display events that are no longer in the event list to check the status of previously-issued events.

[Figure]

To display events, you can use the event display start-time specification function on the Monitor Events and Severe Events pages of the Event Console window, or the slider.

Tip:

Attaching a memo to an event:: By attaching a memo to an event, you can make a note on the status of the investigation for the event. For details about how to attach a memo, see 3.10 Setting memo entries in the Overview and System Design Guide.
If the position of the slider is reset:: If auto-scrolling is enabled, every time a new event is registered, the position of the slider is reset to display the new event. If you do not want the slider to move, disable auto-scrolling. For details about how to enable or disable auto-scrolling, see 2.1 Overview of the Event Console window in the manual GUI Reference.

Keywords:

event, search, display time, Monitor Events page, event display start-time specification function, past

Organization of this section

To Page Top