3.3.2 Verifying that events from unmonitored hosts are not displayed
After you have specified the common exclusion conditions for the filter, make sure that events from the unmonitored hosts are not displayed in the event list. This subsection describes how to verify that events issued on host 1 are displayed in the event list, and that events issued on hosts A and B are not displayed in the event list.
Prerequisites
The following conditions must be satisfied:
-
OS user mapping was configured according to the procedure in 2.2.1 Using the user mapping feature to map a JP1 user account to an OS user account.
-
A basic configuration system is set up according to 2.1.1 Procedure for setting up a system by using IM Configuration Management.
Procedure
-
In the Event Console window, click the Execute Command button. The Execute Command window appears.
-
Set the items in the Execute Command window as described below, and then click the Execute button.
Item
Setting
Command type
Select Command of managed host.
Event information to inherit
Clear the Inherit event information check box.
Target host
Enter the following:
hostA
Command
Enter the following:
-
In Windows:
"Base-path\bin\jevsend" -e SEVERITY=Warning -m Command executed from host A.
-
In Linux:
/opt/jp1base/bin/jevsend -e SEVERITY=Warning -m Command executed from host A.
An event of severity level is Warning is issued on host A.
-
-
Repeat steps 1 and 2. Set the items in the Execute Command window as described below, and then click the Execute button.
Item
Setting
Command type
Select Command of managed host.
Event information to inherit
Clear the Inherit event information check box.
Target host
Enter the following:
hostB
Command
Enter the following:
-
In Windows:
"Base-path\bin\jevsend" -e SEVERITY=Warning -m Command executed from host B.
-
In Linux:
/opt/jp1base/bin/jevsend -e SEVERITY=Warning -m Command executed from host B.
An event of severity level Warning is issued on host B.
-
-
Repeat steps 1 and 2. Set the items in the Execute Command window as described below, and then click the Execute button.
Item
Setting
Command type
Select Command of managed host.
Event information to inherit
Clear the Inherit event information check box.
Target host
Enter the following:
host1
Command
Enter the following:
-
In Windows:
"Base-path\bin\jevsend" -e SEVERITY=Warning -m Command executed from host 1.
-
In Linux:
/opt/jp1base/bin/jevsend -e SEVERITY=Warning -m Command executed from host 1.
An event of severity level Warning is issued on host 1.
-
-
Verify that the event list contains the event issued on host 1, but does not contain the events issued on hosts A and B.
Related topics
-
2.1 Overview of the Event Console window in the manual GUI Reference
-
2.22.2 Event Attributes page in the manual GUI Reference
-
2.38 Execute Command window in the manual GUI Reference