KAVB2068-E

The command could not be executed because an error occurred.

(S)

Does not execute the command.

(O)

Maintenance information is shown using the end-code:error-information format. Check this information as follows:

• When the end code is 10000, or in the range from 10011 to 10099:

  Make sure that there are sufficient resources on the command execution host.

• When a signal is indicated in the error information:

  Check whether a process output the indicated signal on the command execution host.

If neither of the above conditions occurred or if the problem cannot be corrected, use the data collection tool to collect data, and then contact the system administrator.