18.5.3 Errors in UNIX
- Organization of this subsection
(1) Failure to start the authentication server
- Causes
-
If you changed the setting so that the authentication server stops, you cannot start the authentication server by specifying the local host in authentication-server in the jbssetusrsrv command.
- Action
-
Use the jbssetusrsrv command to specify the local host in authentication-server, and then perform the following:
cd /etc/opt/jp1base/conf cp -p jp1bs_spmd.conf.session.model jp1bs_spmd.conf
(2) Failure to start the event service because an error such as KAJP1005-E or KAJP1852-E occurred
- Causes
-
The possible causes are as follows:
-
The values of kernel parameters are set without taking JP1/Base and other products into consideration.
-
Although the directory specified in the event server index file (index) has a symbolic link, there is no directory at the destination of the symbolic link.
-
The directory to be created when the event service starts cannot be created because of inappropriate permissions or other reasons.
-
- Action
-
To correct the problem, perform one of the following actions. Each number corresponds to the respective number of the causes described above:
-
Re-set the values of kernel parameters. For details on the values of kernel parameters, see G. List of Kernel Parameters.
-
Create the directory and re-create the symbolic link.
-
Change the user privileges to superuser privileges, and then re-execute the event service.
-