jbs_stop (UNIX only)
- Organization of this page
Function
The jbs_stop command stops JP1/Base (the event service and process management including user management).
To automatically stop JP1/Base by executing this command, run the following script after completing JP1/Base installation and setup:
cd /etc/opt/jp1base cp -p jbs_stop.model jbs_stop
Format
jbs_stop
Required execution permission
Superuser or JP1/Base administrator permission
Command directory
/etc/opt/jp1base/
Notes
-
This command does not stop the log-file trap management daemon, which runs on both the logical and physical hosts. You can stop the daemon by executing the jevlogdstop command after executing the jbs_stop command. However, if the log-file trap management daemon is active on the logical host, executing the jevlogdstop command will disable log file trapping on that logical host. Before executing the jevlogdstop command, make sure that the log file trapping is not being used on the logical host.
-
After issuing the stop request to the JP1/Base processes, this command ends with the return value 0. To check whether the processes have stopped correctly, after the jbs_stop command has finished, use the jbs_spmd_status command.
Return values
0 |
Normal end |
1 |
More than one argument was specified. |