7.2 Starting and stopping JP1/Base (in UNIX)
On a UNIX system, you can start and stop services using commands.
#1: At JP1/Base installation, the Hitachi Network Objectplaza Trace Library (HNTRLib2) is set by default to start and end automatically.
#2: The log-file trap management daemon is required to perform log file trapping. You can shut down the JP1/Base system while the log-file trap management daemon is active.
#3: The jbs_start.model is stored in the /etc/opt/jp1base directory. Using the jbs_start.model, you can start all services other than the Hitachi Network Objectplaza Trace Library (HNTRLib2). Use this script to start JP1/Base in normal circumstances.
#4: The jbs_stop.model is stored in the /etc/opt/jp1base directory. Using the jbs_stop.model, you can stop all services other than the Hitachi Network Objectplaza Trace Library (HNTRLib2) and log-file trap management daemon. Use this script to stop JP1/Base in normal circumstances. In a system other than a cluster system, if you want to stop functionality other than HNTRLib2 without running JP1/Base on every logical host, execute the jevlogdstop command after you execute jbs_stop.model.
For details on the above commands, see 15. Commands.
In UNIX, you can make process management (including user management), the event service, and the log-file trap management daemon all automatically start when the system starts up. You can also make process management and the event service automatically stop when the system shuts down.
The setup required for automatic start and stop control is explained below.
- Organization of this section