4.8.4 Items in the Attribute Settings window (check box part in the guide area)
|
The following describes the items in the Attribute Settings window.
- Organization of this subsection
(1) Displayed string text box
Enter the label for the check box. By default, Check box is displayed as the label.
An error occurs in the following cases:
-
A character string of more than 1,024 bytes is entered. (When using double-byte characters, enter a label of no more than 340 characters.)
-
A character string containing an ASCII code from 0x00 to 0x1F or 0x7F is entered.
(2) Guide Part ID text box
For the Guide Part ID, enter a character string (no more than 20 single-byte characters) that uniquely identifies the Guide Part. Use the Guide Part ID text box when you change an automatically set Guide Part ID.
You can enter single-byte alphanumeric characters, single-byte hyphen (-), and single-byte underscore (_). You can also enter an empty character string. When entering a character string other than an empty character string, enter a character string that is unique in the same guide area.
(3) Change the default value to the check status check box
If you select this check box, the placed check box is displayed in the selected state. This check box is not selected by default.
(4) The Checkbox must be specified check box
If you select this check box, a message appears when the user attempts to proceed in the Operational Flow without selecting the placed check box. This check box is not selected by default.
If direct transition from the relevant node to any other nodes in the Operational Flow is enabled, the setting using the The Checkbox must be specified check box is ignored (because the operation can unconditionally transition to any selected node).