8.1 Property files whose settings need to be specified
The following table lists and describes the property files whose settings need to be specified when the system is configured.
Type |
File name |
Usage |
Section |
---|---|---|---|
User setup property file |
ucnp_setup_user.properties |
Specifies the setup information that is applied when the npsetup command (set up) is executed.
|
|
Service property file |
ucnp_service.ini |
Specifies the search data update interval and the operation log analysis time. |
|
User property file |
ucnp_user.properties |
Specifies the Navigation Platform operating environment.
|
|
User message properties file |
ucnp_message_user.properties |
Customizes messages that are displayed in the Guide area of the Operational Content Execution Window.
|
|
User label property file |
ucnp_label_user.properties |
Customizes the character strings that constitute links and are displayed in the header area of the Operational Content Execution Window. |
- Notes:
-
-
Of the properties specified in the property files listed in the table above, do not edit any properties other than those explained in the subsequent sections.
-
When you configure environments, copy the property files as an administrator. Otherwise, the property files cannot be copied correctly because they will be redirected to user folders. When you change settings, start the editor with Run as administrator, and then edit the property files.
-
When you have edited any of the property files, except for the user setup property file, you must restart Navigation Platform to apply the edited settings to Navigation Platform. Execute the npstart command (start) after you have executed the npstop command (stop).
-