The table below and Table C-2 RDAREA status transitions (2/2) show the RDAREA status transitions during execution of operation commands.

Table C-1 RDAREA status transitions (1/2)

RDAREA status (before transition)	RDAREA status (after transition)
	Open	Shutdown	Closed	Shutdown and closed	Reference-possible shutdown	Reference-possible shutdown and closed
Open#1	--	pdhold	Transaction termination#3	pdhold -c	pdhold -i	N
Shutdown	pdrels or pdrels -o	--	N	pdclose	pdhold -i	N
Closed	pdopen, pdrels -o, or transaction startup#2	N	--	pdhold or pdhold -c	N	pdhold -i
Shutdown and closed	pdrels -o	pdopen	pdrels	--	N	pdhold -i
Ref-possible shutdown	pdrels or pdrels -o	N	N	N	--	pdclose or transaction termination#3
Ref-possible shutdown and closed	N	N	pdrels	pdhold or pdhold -c	pdopen or transaction startup#2	--
Ref-possible backup-hold	pdrels or pdrels -o	N	N	N	N	N
Ref-possible backup-hold and closed	pdrels -o	N	pdrels	N	N	N
Updatable backup-hold	pdrels or pdrels -o	N	N	N	N	N
Updatable backup-hold and closed	pdrels -o	N	pdrels	N	N	N

Legend:

--: Not applicable

N: Cannot be in this RDAREA status after the transition

Ref: Reference

Synchro: Synchronization

#1: The pdclose command will result in an error because the RDAREA is not shut down.

#2: This status changes if the RDAREA open timing is either DEFER or SCHEDULE.

#3: This status changes if the RDAREA open timing is SCHEDULE.

Table C-2 RDAREA status transitions (2/2)

RDAREA status (before transition)	RDAREA status (after transition)
	RPH	RPHC	Updatable backup-hold	Updatable backup-hold and closed
Open#1	pdhold -b	N	pdhold -b -u	N
Shutdown	N	N	N	N
Closed	pdhold -b#5	N	pdhold -b -u#5	N
Shutdown and closed	N	pdhold -b#2	N	pdhold -b -u#2
Ref-possible shutdown	N	N	N	N
Ref-possible shutdown and closed	N	N	N	N
Ref-possible backup hold	--	Transaction termination#3 or pdclose#4	N	N
Ref-possible backup hold and closed	Transaction startup#2 or pdopen#4	--	N	N
Updatable backup-hold	N	N	--	Transaction termination#3
Updatable backup-hold and closed	N	N	Transaction startup#2	--

Legend:

N: Cannot be in this RDAREA status after the transition

RPH: Reference-possible backup hold

RPHC: Reference-possible backup hold and closed

--: Not applicable

Ref: Reference

#1: The pdclose command will result in an error because the RDAREA is not shut down.

#2: This status changes if the RDAREA open timing is either DEFER or SCHEDULE.

#3: This status changes if the RDAREA open timing is SCHEDULE.

#4: This status changes if the RDAREA is not in reference-possible backup hold (update WAIT mode).

#5: This status changes if the RDAREA open timing is DEFER.