Operands related to the message output suppression facility

246) pdmlgput -s output-selection

{-c ALL | [-l message-severity]

-m message-ID[,message-ID]...}

Specifies options for HiRDB's output of messages to the the event log. The following can be specified:

When this operand is not specified, output of messages to the event log is not suppressed.

-s output-selection: Specifies the message output suppression option for the indicated messages.; Y: Outputs the indicated messages.; N: Suppresses output of the indicated messages.; For details about suppression of message output to the the event log, see the HiRDB Version 9 System Operation Guide.

-c ALL: Specifies that output of all HiRDB message to the the event log is to be suppressed.; When this option is specified, specify N for the -s option.

Note: Normally, it is recommended that this option not be specified, because it makes it difficult to diagnose errors.

-l message-severity: Specifies the severity level to be set for messages that are output.; To specify this option, you must also specify Y in the -s option.; E: Error message; W: Warning message; Q: Waiting message; I: Information message; For details about changing the severity level of messages that are output to the the event log, see the HiRDB Version 9 System Operation Guide.

-m message-ID[,message-ID]...: Specifies the IDs of the messages that are to be output or that are to be suppressed. Do not enter the message severity level that follows the hyphen (-) in a message ID. (For example, for KFPS01820-E, specify KFPS01820.); Specifying a message that is not designed to be output in the event log for this option is the same as not specifying it.

Operand rules

You can specify multiple lines of this operand.
If multiple lines of control are specified for the same message using the ALL specification or message ID specification, the latter specification takes precedence.

Relationship to other operands

pd_mlg_file_size: When message output is suppressed, specifies the maximum size of the message log file.
pd_mlg_msg_log_unit: When messages are to be output, specifies the output destination for message logs (the system manager unit or the unit that outputs each message).